Features:
The Transmitter (TX):
The Receiver (RX):
Optional Accessories:
Resources:
Features:
- Extremely simple, menu operated, backlit user interface
- Simultaneous single and multi (3) phase identification
- Can be used on energized and de-energized circuits
- Can be used on single and multicore cables
- Load current and frequency measurement
- Non-volatile memory to store parameters
- 3 cables can be identified in one action
The Transmitter (TX):
Input Supply Voltage
Integrated Battery: 12V SLA (Sealed Lead Acid), 2.9Ahr
AC Shore Power: 85 ~ 264VAC, 47~440HZ / 120-370VDC
Auxiliary DC: 12V DC auto type supply [9.6~15V DC reverse protected]
AC Shore Power: 85 ~ 264VAC, 47~440HZ / 120-370VDC
Auxiliary DC: 12V DC auto type supply [9.6~15V DC reverse protected]
Output Pulse Voltage
125V peak, single phase or three phase
Output Pulse Cycling
Single Phase ~1.2 seconds average; Three phase ~3.6 seconds average
Output Pulse Current
100A max. Actual current dependent on loop impedance
Power Consumption
21W
Battery Status
LED indication: Full (Green), Medium (Amber), Low (Red), Critical (Blinking Red)
Battery Life
7 hrs (Single Phase)
Charging Time
4.5 hrs
Pulse Indication
LED and audio for each channel with status indication
Environmental Protection
IP52
Operating Temperature
14 ~130°F / -10 ~55°C
Dimensions
9.4” x 4.7” x 3.5”
240 x 120 x 90 mm
240 x 120 x 90 mm
Weight
4.6 lbs / 2.1 kg
The Receiver (RX):
Input Supply Voltage
4 AA Batteries (6.0V nominal), Alkaline or rechargeable
Power Frequency Current
0 ~ 500A (50/60 Hz) +/- 10% at reading, Resolution: 0.1A
Memory
Non-volatile storage of ID parameters
Display
128 x 64 pixel, monochrome
Battery Life
>24 hrs
Environmental Protection
IP62
Operating Temperature
14 ~130°F / -10 ~ 55°C
Signal Detection Sensor
Flexible pickup coil, ID: 180mm/7.0” (CAT III 1000V)
Dimensions
9.4” x 4.7” x 2.2”
240 x 120 x 55mm
240 x 120 x 55mm
Weight
1.6 lbs / 0.7 kg
Note: Due to continuous development, the information may change without notice.
Optional Accessories:
- 900 010 – Clamp-on CTs (CAT III 600V)
- 900 030 – Receiver (RX) Extension Cable
- 900 031 – L1 & L2 Extension Cables (Pair)
- 900 104 – Line Output Test Lead with Clamps
- 900 105 – CT Paralleling Test Leads (Pair)
- 900 106 – Transport Case for (2) Clamp-on CTs
- 900 111 – RX Handheld Pickup Sensor “PUC”
Resources:
